Engage Side Supports
Firstly slide all of the side supports so they are bunched up at the opposite end of the rail away from the tray.
Lift the front of the rail slightly and slide the first side support over the slot in the tray. Lower the channel nut into the
slot and slide the side support towards the end moulding.
Repeat this process for all side supports, sliding the rail further onto the tray as you go.
Side Support
End without Channel
Nuts Fitted
7
Align End Supports
Adjust the end supports (with hardware fitted) so they align with the appropriate plank ready for fitment. Refer to the
images below for correct plank alignment to suit your tray.
5 Plank Trays
4 Plank Trays
8
Insert First End Supports into Slots
Lower the rail assembly onto the tray so that
the channel nuts fitted to the end mouldings
locate within the slots at the front of the tray.
Next slide the rail assembly onto the tray
slightly so the nuts engage in the channel.
End Support
(with hardware fitted)
Slot
9
Page 3 of 6
Rhino Pioneer Full Rail Kit
