Rheem Stellar 850330, Руководство пользователя и инструкции по установке

Страница: 38 / 44

LIGHTING THE WATER HEATER
38
TEST THE WATER HEATER AFTER INSTALLATION

The operation of the water heater must be thoroughly checked by the
installer.

The burner flame must light smoothly and quickly from the pilot flame, and
must go out quietly and completely.

The main burner flame must be stable, although slight lifting at the front
edge of the burner is acceptable when the burner is cold.

The main burner flame should be blue, with a clearly defined inner cone -
luminous yellow or "floating" flames are not acceptable, and must be
corrected by opening the air shutter (refer to
“Air Shutter”
on page 38).

Check the test point pressure and compare with the rating label. The
pressure regulator is not adjustable and if the test point pressure is not
within 5% of the specified value, refer to Rheem Service or their nearest
Accredited Service Agent.

If unable to get the water heater working properly, contact Rheem Service
or their nearest Accredited Service Agent.

When satisfied everything is working properly instruct the user in the correct
method of operation.
AIR SHUTTER
The air shutter is a hinged flap in the burner aeration tube. It may require
adjustment on installation.

For a Propane, Butane or Universal LPG model, the air shutter should be
fully open.

The shutter is held in place by a screw on the side of the burner aeration
tube.
Note: A Natural gas model does not have an
air shutter.
CLOSE DOWN PROCEDURE
1. Turn the gas control knob to the
“

” position (pilot). This setting will leave
the pilot flame alight however the main
burner will not be able to light.
2. Turn the gas control knob to the "

" (off)
position. This setting shuts the gas
control down completely.