Rheem RTEC-04 E03, Инструкция по эксплуатации и монтажу

Страница: 12 / 15

11
/
15
3--- After the unit is supplied with power, please turn on the water and then the appliance will start work. The
min water flow to activate the unit is 1.5L/min.
4--- Turn off the water flow, the appliance will stop working. It is not necessary to turn off the heater by
pressing any key on front panel.
5--- Press
to adjust the setting temperature between 30°C -55°C, Temperature setting will cycle
among 30°C-55°C -30°C, single press the key, the setting temperature will be up 1°C, only in the
working condition, the press key is available to adjust the temperature. The default setting temperature is
55°C.
6--- Press
continuously for 3 seconds, the setting temperature will be circularly setup among
38°C -42°C -55°C -42°C -38°C.
7---
is the function key, If you need to install the unit upside down, Please press and
hold for 3 seconds, the temperature display Arabic numerals will rotate 180°.
8--- There is overheat production function for the appliance, while the outlet temperature reaches 60°C, the
appliance will decrease the power level automatically, only after the hot water temp. drop to 53°C, it will
recover to work. In this state
,
you should reduce the setting temperature.
9--- There is real-time leakage detection function, while there is a leakage, the appliance will stop working
automatically.
10--- Please check hot water with hand before using.
If the unit will not be used in winter, drain out water
completely so that the heater will not be frozen.

Please periodically clean inlet strainer and the shower to keep a free water flow.