6. For Units Without a Timer
Decal Functions
A) Cal Reset Button
B) Filter Reset Button
C) Power LED (Red)
D) Ready LED (Green)
E) Filter LED (Orange)
A) Cal Reset Button
The
(Cal Reset)
button allows the
operator to re-calibrate the boiling
temperature of the boiling water unit.
The reset function is enacted when the
operator switches the boiling water unit
off at the electrical supply, and then turns
the boiling unit back on while holding the
(Cal Reset)
button down. The electronic
controller will then go through a series of
procedures that will take approximately
10 minutes, after which time the boiling
water unit will be re-calibrated.
B) Filter Reset Button
The (Filter Reset) button is used to count
the volume of water passed through the
unit, to help determine the life of any filter
attached to the unit. To reset the filter the
operator only has to push the (Filter
Reset) button for 10 seconds.
C) Power LED (Red)
The red Power LED shows that there is
mains voltage going to the electronic
controller.
D) Ready LED (Green)
The green Ready LED shows the status
of the water temperature within the
Boiling Water Unit.
When the green Ready LED is flashing, it
means that the water temperature is
below the operating range of the unit.
When
the
green
Ready
LED
is
continuous, the water temperature is at
the required operating temperature.
E) Filter LED (Orange)
The orange Filter LED shows the status
of the attached water filter. When the
orange Filter LED is flashing, 4000 Litres
have flowed through the Boiling Water
unit. This then prompts the user to check
the in line water filter to see if it needs
replacing. To reset the filter LED, just
push the (Filter Reset) button for 10
seconds.
10.
