RGC HYDRAPAK HV185510C, Инструкция по эксплуатации

Страница: 10 / 21

WARNING:
WHEN OPERATING THE HYDRAPAK, OBSERVE ALL SAFETY PRECAUTIONS DESCRIBED
IN THE HYDRAPAK, ENGINE AND HYDRAULIC TOOL INSTRUCTION MANUALS.
FAILURE TO COMPLY COULD RESULT IN DEATH, SERIOUS INJURY AND/OR
EQUIPMENT DAMAGE.
9. Do NOT attempt to make any equipment adjustments during operation.
3.3 STOPPING THE HYDRAPAK
At the end of operation, secure the equipment to prevent unauthorized use. Never assume you will find the equipment in the
same condition that you left it. Proceed as follows:
1.
Let the HydraPak run at idle for about five (5) minutes to cool hydraulic oil and components, or for ten (10) minutes
under severe operating conditions.
2.
Turn both flow control knobs to the OFF position.
3.
Turn the key counter-clockwise to OFF. When the ignition key is in the OFF position, no electrical power is available
to operate the fan or any accessories.
CAUTION:
INSURE THE IGNITION KEY IS TURNED OFF TO PREVENT POWER DRAINAGE FROM
THE BATTERY.
4.
Turn the fuel valve on engine OFF.
CAUTION:
INSURE THE FUEL VALVE IS TURNED OFF BEFORE TRANSPORTING THE HYDRAPAK.
7