RGC HL9000, Инструкция по эксплуатации

Страница: 15 / 33

11
Figure 3-5.
Bunk Assembly
3.9 MAKING POWER CONNECTIONS
1.
Before making any hydraulic connections, inspect all hydraulic lines, fittings and hoses for leaks and risks of rupture as
follows:
a. Inspect each hydraulic line, fitting, and hose for breaks, cracks, worn spots, bulges, chemical attack, kinks or any
other damage. Never try to stop any detected leak with any body parts. Do not put your face close to suspected
leaks. Hold a piece of cardboard close to suspected leaks and then inspect the cardboard for signs of hydraulic oil.
b.
Replace a damaged line, fitting or hose immediately. Never repair the part.
WARNING:
LIQUID UNDER HIGH PRESSURE CAN PIERCE THE SKIN, CAUSING DEATH OR SERIOUS
INJURY. IN CASE OF INJURY, GET IMMEDIATE MEDICAL ATTENTION.
3.
Wipe the mating surfaces of the hose couplings as well as the control box couplings with a clean rag prior to making
connection.
4.
Insert the hoses through the flexible cable boot in the back of the control box. Connect the hose couplings.
5.
If the quick connect fittings are difficult to attach, relieve some of the pressure in the system by pushing in on the tip of
the male hose connector. Pressing the tip against a clean hard surface is suggested. Use caution not to damage the
fitting. This will release a small amount of fluid, which is acceptable. Once the pressure has been released, you should
be able to connect both hoses.