RGBlue BM3500B, Инструкция по эксплуатации

Страница: 35 / 40

Maintenance after Use
·After finishing the use of the product, remove the lens, etc.
(without disconnecting the modules) and soak the product in
fresh water under normal temperature for more than one hour to
eliminate the salt content.
·After taking the product out of the fresh water, wipe with a dry
cloth to eliminate moisture and let the product dry naturally in a
place not exposed to direct sunlight.
(NOTE) Do not dry the product with a hair dryer or direct
sunlight, as this may cause degradation or deformation
of the product and O-ring, which may eventually lead to
a failure or water penetration.
·When the product is not to be used for a long period,
disconnect the Light Module and Battery Module, and attach
the insulation cap to the Battery Module before storing the two
modules.
·The special O-ring and special silicon grease are consumable
articles. If you run out of the spares, please purchase them.
·The battery gradually depletes even in a storage condition since
the Battery Module incorporates a control PCB. Note that it is not
malfunction. It is recommended to recharge the battery before use.
35