RGBlink MSP 329, Руководство пользователя, Страница: 12 / 35

MSP329 User Manual
11
No. Name Description
5 Audio Output

AUDIO OUT:
connect this 3.5 mm stereo tip-ring-sleeve port to an
audio output device such as a speaker and an amplifier to output
unbalanced, stereo audio signals.
6 IP Stream Input
LAN (POE): 10/100/1000 Base-T port, connect this port to a gigabit
Ethernet switch for IP stream input, device control and device
management.
Default protocol:
IP address: 169.254.x.x
Subnet mask: 255.255.0.0
DHCP: Off
Auto-IP: On (Default)
Link speed
and duplex level:
Auto-detected
RJ-45 port LEDs:
Link LED (Left): This green LED lights to indicate a good
network connection.
Activity LED (Right): This yellow LED blinks to indicate
network activity.
7
Reset Button
(Recessed)
RESET: use this button to reset device or quickly remove link relationship
between decoder and encoder.

Device reset :
When MSP329 RX is powered on, use a pointed stylus to hold down the
RESET button for five or more seconds, and then release it, it will reboot
and restore to its factory defaults. This function will disconnect decoder
from encoder.
Note:
When the settings are restored, your custom data is lost.
Therefore, exercise caution when using the RESET button.

Remove decoder and encoder link relationship quickly:
When encoder is routed to decoder using PC configurator, VisualM or IP
controller, hold down the RESET button for less than five seconds, and
then release it, it reverts to the link relationship between encoder and
decoder set via the link DIP switch. This function applies to decoder only.
8 Power Input DC 12V: connect this port to the supplied
12 V 1 A power adapter.