Stock Code 873117 en.rgble.com 400-1661-021
P/N: S00302
5.
Operation Controls and Functions
5.1
Front Panel
Power button and indicator:
When this device is switched to the standby mode by pressing power button, the indicator will
illuminate red. When switching to power on mode, the indicator will illuminate blue.
IR Window:
Receiving IR signal from remote control.
Input Source buttons:
Press these buttons for source selection. The active source will be
illuminated
to corresponding
indicators on the front panel.
Operation buttons:
Pressing
“OK/MENU” button enters the OSD immediately. Then the user can navigate using
the 4-way arrow
buttons. A new OSD setting is confirmed by pressing “OK/MENU” button.
Pressing "EXIT/AUTO" will exit OSD when OSD is displayed. Press "EXIT/AUTO" for 5
seconds to auto switch on/off. When the button LED light on, means auto switch on.
Pressing
“MIC-/+” buttoned creases or increases MIC volume. Press “VOL+/- “button to
increase or
decrease “Master volume”.
Pressing
“MIC-“and “MIC+” buttons simultaneously will reset the switcher HDMI/HDBT output
resolution to 720P/60.
Pressing
“VOL- “and “VOL+” buttons simultaneously will lock/unlock the front panel; these
two button LED will light on when the front panel is lock on.
5.2
Rear Panel
Control ports:
LAN:
This port is the link for Web GUI control; connect to an active Ethernet link with an RJ45
terminated cable.
RS-232:
Serial control port, 3P captive screw connector, connects with a control device (such as a
computer) to control the switcher or other device connected with the HDBT receiver.
IR IN:
Connects with IR receiver cable (with carrier wave), to receive IR signals sent by the IR
remote or remote controller of other input/output device.
IR OUT:
Connects with IR emitter cable used for controlling the local source device or the switcher.
CONTACT IN:
This input control reserving for direct source input selection. Connect ground pin
(mark as
on panel) with following pin number for individual source selection.