4016 Harry Hines Blvd Dallas, Texas 75219 • 972-650-1855
LED RGB ColorFlex
LED Cove Lighting
P 2
15
0mm
Read all instructions
DISCONNECT POWER BEFORE INSTALLING OR CUTTING!
1. Cut ColorFlex light only on the marked intervals. Cut in the center. It is easier to cut the back side where there are no solder points.
2. Carefully remove the PVC as in picture with sharp blade but do not cut the PCB. Cut the clear PVC back to reveal the full Copper connectors. The
Copper connectors should be 6 to 7 mm exposed from the PVC (tongue connectors). Carefully note that the connection points must line up. V1 to V1, G
to G, R to R and so on.
R B G
G
G
R
R
B
B
V2
V 2
V1 and V2 are positive (+) pole of LEDs (white wires).
Seal end cap by heat shrink or glue
Note: 5 wires RGB
- V1, V2: White wires (2x) Positive
- B: Blue Wire (-)
- G: Green wire (-)
- R: Red (-)
Silicone
P 1/2
Do not bend sideways
Flexible on one axis
Deflection:
The bend radius must not
exceed150mm (6”)
150 mm
Step 3:
Inspect the plastic connector housing to ensure the metal tabs in the plastic housing are:
·
Still in place, uniform in shape & springy.
Step 4:
Place RGB Border Light in the bottom plastic connector housing.
Step 5:
Place the black wire connector assembly in the other side of the bottom plastic connector housing.
Step 6:
Ensure that the connectors do not touch one another when in the plastic housing.
Step 7:
Test fit the upper plastic connector housing. Ensure that it will comfortably fit and that the metal tabs of the upper and lower plastic connector
housing will touch the copper connectors on all sides.
Step 8:
Screw the connector together using a criss-cross pattern to ensure uniform and even pressure on the connecter while screwing it together.
Step 9
: Test the RGB strip by lighting one color at a time.
Note the following when testing:
·
Both White wires are both positive and both need to be connected to the positive
·
The color of the wires should reflect the color of the lights
·
Test the RGB strip by lighting one color at a time.
If Green lights up when the blue should light up and the Blue lights up when the Green should light up then flip the black wire connector assembly
over inside the plastic housing and retest.
WARNING:
ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION.
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION OF THE POWER
SUPPLIES AND/OR LED BORDER LIGHT
DISCONNECT POWER BEFORE INSTALLING OR SERVICING!
When using power supplies; the following basic safety features should be verified in addition to any other application
specific concerns and local safety codes:
Short circuit protection
Overload protection
Overheat protection
Correct wire gauge
Correct output voltage, including consideration for ripple and spikes.
