RG Avioni Vector, Руководство по сборке

Страница: 7 / 8

www.rcavioni.com 065/33-99-363 office@rcavioni.com www.rcavioni.com 065/33-99-363 office@rcavioni.com
Push rod/z-bend assembly show below:

(3) 13” carbon rods (1) for rudder and (1) for elevator and the 3
rd
is cut in half for each aileron.

(4) horns (1) Aileron differential hole and (2) servo arm
extensions

(8) Z-bends

(8) 1” shrink tubing
-Clean and scuff each metal z-bend to remove oil or dirt to allow them to
adhere stronger to the CA Glue and Carbon Fiber.
-Apply 1 drop of CA glue then apply heat shrink tubing (we used a
lighter).
Be careful not to have the CA glue run down and get in the horn’s eye holes.
Begin z-bends connections for each control surface first. Then tape or pin the control surfaces to a neutral
position before you finish trimming carbon rod finial length. Trim carbon rod ¾” before servo horn, then
repeat z-bend process to complete control linkages.