www.rcavioni.com 065/33-99-363 [email protected]
www.rcavioni.com 065/33-99-363 [email protected]
1
st
step.
Install the black motor stick mount and also the 9g aileron servo and with glue as shown below. Then glue
main wing to the mid-fuse piece and let dry. Now pull fuse slightly apart which will allow the assembled
elevator to fit into place toward the rudder (do not glue this piece in as this time)
Carefully pull apart the fuse to insert the man wing assembly. Find all tabs which will keep all pieces straight.
Once all pieces are square to themselves apply a small bead of glue around all matting surfaces. *remember its
best to go light on all gluing since you can always add more if needed, too much glue isn’t what we want*
The nose pieces are installed the same way, make sure everything is square before the glue is dry. **Please
note when installing the motor there will be an alum flange mount which is held on with small set screws, this is
not needed with the supplied stick mount remove this mount and discard.**
www.rcavioni.com 065/33-99-363 [email protected]
