Copyright, RFXCOM 2022
RFXtrxWifi/USB User Guide Rev. 0.2
page 4 / 10
4. Install the transceiver.
The RFXtrxWifi and RFXtrxUSB can be equipped with the RFX69 transceiver module.
This RFX module must be inserted in the RFXtrxWifi / RFXtrxUSB PCB if the RFM module has a
Push-To-Fit (PTF) connector. Push the module in the connector holes on the component side. The
RFM69 module has on one side 8 pins and 7 pins on the other side to avoid wrong installation.
4.1. RFX69
The RFX69 is a RFM69 with PTF connector. At this moment only 868MHz is used with RFXtrx868XL
firmware.
RFXtrx433XXL firmware for the RFX69-433MHz is not yet available.
RFXtrx868XL firmware for the RFX69-868MHz is available and supports:
Protocol
Protocol
receive
transmit
Alecto ACH2010
Alecto ACH2010
Y
-
Alecto WS5500, FineOffset WH2900,
Ventus W830
Alecto WS5500
Y
-
Davis Vantage Vue EU
*
Davis EU
Y
-
Edisio
Edisio
Y
Y
FS20
FS20
Y
Y
Itho CVE RFT
Itho CVE RFT
-
Y
Itho CVE ECO RFT
Itho CVE ECO RFT
Y
Y
Keeloq (unencrypted part only)
Keeloq
Y
Y
Orcon
Orcon
Y
Y
Visonic CodeSecure (unencrypted part only)
Visonic
Y
-
Visonic PowerCode
Visonic
Y
-
* based on information available at: wxforum.net – “Implementing a Si1000 based wireless receiver for
Davis ISS data” and madscientistlabs.blogspot.com
Important:
it is only possible to enable one protocol for receive in the RFXtrx868XL because of the
used transmission techniques at 868MHz.
4.2. RFX95
The RFXtrxWifi is prepared to hold the RFX95 transceiver.
RFX95 firmware is not yet available.
