RFS INSTALLATION GUIDELINES
HYBRIFLEX
®
CABLE|603400210500|September 2020
Visit
for the most current product specifications
Page 3 of 43
Introduction to HYBRIFLEX®
RFS’ HYBRIFLEX Remote Radio Head (RRH) hybrid
feeder cabling solution combines multiple elements,
including optical fiber and DC power, for RRHs in a single lightweight cable, making it the world’s most
innovative solution for RRH deployments. It was developed to reduce installation complexity and cost at
macro sites. HYBRIFLEX allows mobile operators deploying RRH architecture to standardize the RRH
installation process. HYBRIFLEX combines optical fiber, power and alarm wire in a single jacketed cable and
can connect multiple RRHs with a single feeder. Standard RFS CELLFLEX® coaxial cable accessories may be used
with HYBRIFLEX cable. Both pre-terminated and on-site terminated options are available. The rugged jacket
facilitates easy transportation, handling, and installation.
These short instructions were written for qualified and experienced personnel. They describe, in few words,
the main points that MUST be noted during installation, without any claim of completeness.
Any liability or warranty for results of improper or unsafe use is disclaimed!
General remarks:
In principle, care must be taken to avoid all such strain that may cause permanent deformation on the cable,
e.g. going below admissible bending radii, kinking, applying too high tensile stress or forcible deformation (e.g.
pulling over sharp edges, over tightening of clamps etc.).
