TRAP Remote Controls
DS
-
TRAP
-
10 Page 7
With this system, you can pair together any individual trans-
mitter switch with any receiver relay switch. Without opening
either enclosure:
1. Remove the green transmitter rubber over-boot
2. Briefly (~1 second) place the transmitter next to the re-
ceiver in the position shown and then remove it.
3. The receiver will buzz once (One buzz means the receiver
unit is ready to allocate a transmitter to relay output 1)
To select relay output 2, 3 o 4, briefly place the trans-
mitter again so that the Buzzer Buzzes to indicate the
Relay output 2,3, or 4.
4. Press the switch on the transmitter which you wish to
pair
5. The receiver will buzz twice to confirm pairing
6. Repeat for any additional transmitter switches
NOTE: Each receiver has a maximum memory for up to 28
pairings, these can be from any switches on any transmitters
Advanced operation - Pairing a Transmitter Button
1. Hold the transmitter in the position shown in position for ~10 seconds.
2. The receiver will sound a long buzz to confirm all Transmitters are erased
Advanced operation - Erasing Receiver
