QUANTAFOB
Advanced Operation - Pairing a transmitter button using the internal learn
switch
To pair a new transmitter switch follow this procedure
Open the receiver enclosure and extract the Circuitboard assembly
Note!: Any transmitter button can be configured to operate any of the receiver relays.
1. Select the receiver output relay to learn to:
2. Briefly press the receiver Pairing switch (S2) once
3. The Learn LED will flash once to indicate relay 1 is selected
4. After the LED stops flashing, press the Learn switch again to select the next re-
lay channel
5. Repeat step 4 until the required relay is selected.
6. Press the button on the transmitter you want to learn to the chosen relay.
7. The Learn LED will flash to indicate Pairing is complete.
Pairing a Transmitter to a Receiver
The only limitation is that each receiver has a maximum memory for up to 30 pairings,
these can be from the same or any number of transmitters.
Erasing Receivers Memory
1. Press and hold the receiver Learn Switch for approx 10 seconds.
2. When the Learn LED turns ON all memory is erased
NOTE:
You cannot erase individual Tx encoders
