ELITE Low Voltage / Dry Contact Remote control System
ELITE Low Voltage / Dry Contact Remote control System
ELITE Low Voltage / Dry Contact Remote control System
ELITE Low Voltage / Dry Contact Remote control System
DS-ELITE-L-3 PAGE 4
Quick Installation Guide
(systems only)
The Elite system provides 4 switches each capable of switching up to 1.2KW (5A @ 230V). Each channel is
independent and separately controlled. The ELITE-L series Remote control system provides switched contacts
and can therefore be used to switch most voltages be they AC or DC (see maximums on page 7)
1.
Screw the antenna into the terminal
(shown as ANT)
through the top of the enclosure. Tighten the
antenna to ensure a good seal - “finger tight” is sufficient, no tools should be used.
2.
Mount the ELITE system receiver box in the wall in your desired location (see Page 8 for wall
mounting dimensions and information).
3.
Open the enclosure by removing fixing screws from the enclosure front and then removing the front
from the enclosure.
4.
Wire either MAINS, LIVE, Neutral and Earth connections to the power supply screw terminal as shown
below
(shown as A).
Or wire 12-32Vac or 12-32Vdc to the low voltage terminals.
(shown as B)
5.
Wire your desired connections to the relay switches
(shown as C)
6.
Once all required wiring is complete, use the handheld ELITE transmitter to switch the outputs on and
off.
7.
As supplied, the handheld will operate the outputs - Button 1 to output 1, Button 2 to output 2 etc.
8.
All buttons will operate in a latching mode - Press for on, press again for off. It is possible to change the
operation to momentary mode by fitting the links
(shown as D)
9.
For advanced operation such as adding extra transmitters different button mapping options see
Fig 1.1
Fig 1.1
Fig 1.1
Fig 1.1
