RF SOLUTIONS ELITE-KIT, Руководство пользователя

Страница: 4 / 10

ELITE-KIT Remote Control System
Quick Installation Guide
(systems only)
The ELITE system provides 4 switches each capable of switching up to 1KW (4A @ 230V). Each channel is inde-
pendent and separately fused. The ELITE Remote control system provides 230V mains switched outputs via each
terminal.
To install the ELITE System:
1. Screw the antenna into the terminal ( shown as ANT ) through the top of the enclosure. Tighten the
antenna to ensure a good seal - “finger tight” is sufficient, no tools should be used.
2. Mount the ELITE system receiver box in the wall in your desired location (see Page 8 for wall mounting
dimensions and information).
3.
Open the enclosure by removing fixing screws from the enclosure front and then removing the front
from the enclosure.
4. Wire the Live, Neutral and Earth connections to the power supply screw terminal as shown below
(shown as A).
5. Wire your load(s) as required (shown as B)
6. Once all required wiring is complete, use the handheld ELITE transmitter to switch the outputs on and
off.
7. As supplied the handheld will operate the outputs - Button 1 to output 1, Button 2 to output 2 etc.
8. All buttons will operate in a latching mode - Press for on, press again for off. It is possible to change the
operation to momentary mode by fitting the links (shown as C) over both pins.
9. For advanced operation such as adding extra transmitters different button mapping options see
advanced operation section.
Fig 1.1 Fig 1.1 Fig 1.1 Fig 1.1