RFX-RMR
Issue 1.0
page 30 of
41
9.5.11 Audio offset
The analog audio outputs from RFX-RMR Receiver are designed to feed into a 600
Ω
input
impedance.
If the receiver is connected to a higher impedance load, the output level will be ~6dB high. This can be
compensated for by using the ‘audio offset’ function.
Note
: This does
not
change the output impedance from 600
Ω
.
9.5.12 Prog Channels
Each of the ten frequency channels can be independently allocated the required frequency in 0.5MHz
steps.
The
▲▼
buttons are used to select the Channel to be assigned. The Enter button then allows the
▲▼
to edit the required frequency, The A and B buttons move cursor left/right. The Enter button then
stores the value and returns to the Main menu.
9.6
Operations Menu – Analog mode
9.6.1 Ch / Frequency Menu
This menu is not available when the receiver is in “switches” control mode.
The menu is the same as the digital menu as mentioned in clause 9.4.1.
9.6.2 Rx
mode
This menu is not available when the receiver is in “switches” control mode.
The menu used is the same as the digital menu as mentioned in clause 9.4.2.
9.7
Engineering Menu – Analog mode
The Engineering menu provides the method of system configuration; there are no user adjustments or
setups internal to the Rx.
The engineering menu is entered by pressing the “C” and ‘E’ buttons simultaneously for 2 to 10
seconds, then releasing the ‘C’ button.
9.7.1 “Switches and Key-pad” Control Mode
The menu used is the same as the digital menu as mentioned in clause 9.5.1
9.7.2 SW
Inventory
The menu used is the same as the digital menu mentioned in clause 9.5.2, expect the values relate to
