Page 8 Reznor, Coldair, Installation manual, EN 2020-03, 703500 Iss A
3. Packaging, handling and transportation
3.1 Delivery of the unit
When the unit is delivered, the customer MUST check the
condition of the goods
Check the packaging and its contents, if damage
due to transportation is found, record the
damage on the shipping documents to be signed
by the shipping agent and send a copy to your
supplier.
3.2 Handling and transportation
Take care when handling Evaporative Cooling
units. During off loading, handle and position
to avoid damage to the equipment. Avoid
contact with elements, which may damage the
equipment.
The manufacturer declines any responsibility for
damage caused during transportation, loading
and off loading of the evaporative cooling units.
3.3 Lifting
3.3.1 Lifting with a fork lift
3.3.2 Lifting with cables
We suggest to attach the cables as shown, inserting
spacers of an adequate length to prevent the cables from
damaging the casing when tightened. Because of the
heavy weight, RC models, when unpacked, are provided
with punched brackets to allow to lift them by using
appropriate metal tubes.
Place goods down with care. Avoiding dropping
and sudden movements.
UNDER NO CIRCUMSTANCE remain under
suspended loads and inside the movement area
of the lifting equipment.
Make sure that the capacity of the lifting
equipment is adequate for the weight of the
machine. Lifting must only be carried out by
qualified personnel.
3.4 Unpacking the equipment
Free all the components from the packaging material and
collect the packaging to avoid potential danger of fire and
suffocation of persons or animals.
Leave the equipment on its transportation packaging base
with any protection guards mounted, so that the lower
part is raised from the floor to avoid damage, until the
unit is installed.
Disposal of packaging materials must conform
to the regulations in force in the country of
destination where the evaporative cooling unit is
installed
3.5 Storage
During transportation and storage, make sure that the
environmental temperature is between 10 and 50°C.
If the ColdAIR evaporative cooling unit must be stored,
make sure that the relative humidity in the warehouse is
between 5% and 90%.
4. Installation
4.1 General Warnings about installing WA units.
Before proceeding to install, make sure that each
evaporative cooling unit has been unpacked and checked
for damage.
Positioning and installation of the evaporative cooling
units must be carried out by qualified personnel and by
observing the laws in force in the country of destination.
4.2 Positioning and Installation of WA Series
evaporative cooling units.
4.2.1 Wall installation
Fix the support bracket to the wall after the hole for the
air duct has been made. Refer to dimensional sketch on
next page.
On the rear side of the cooling unit (fan side), prepare the
first section of air duct (box section 600 x 600mm).
Position the cooling unit onto the support bracket,
Widen the forks as
much as possible to
balance the load.
Dip the ends of
the forks to avoid
damaging the bottom
of the machine.
