Step 6
Drill the wall then fix the backbox in position. Lift the chassis
(using lifting gear if necessary) onto the studs on the back box
brackets. Refit and tighten the nuts.
Step 7
It is the sole responsibility of the installer to ensure that the
points of attachment to the building are sound. Consultation
with the consultant/architect or owner of the building is
recommended to ensure that a sound, mechanically stable
installation is achieved.
All attachments must be capable of supporting the weight of the
product detailed in Section 1.
It is recommended that the chassis is removed from the back box to
avoid having to support the weight of the product during
installation. To separate the chassis from the back box undo and
remove the nuts shown and lift the chassis away from the back box.
The product can be installed using either M12 drop rods or
fastened direct to the wall using appropriate sized fixings suitable
for the wall surface and the weight of the product.
Step 1
2 Installation details
Remove all packaging. Remove decorative cover. Undo screws
securing the outlet.
Note All outer metal surfaces are covered by a protective plastic
film, which must be removed before final fixing and operating of
the unit.
Adjust the grille by turning the screw inside with an allen key.
Step 2
Step 3
Step 5
Step 4
To wall mount the product, position the back box against the wall
at the desired mounting height and mark through the holes in
the back box brackets to enable the wall to be drilled for the
appropriate fixings.
5
