REYNAERS 062.8620, Руководство по установке

Страница: 12 / 86

12
Â
Step 5: Connect the operating button or the cable to the building
management system with the black connector (A).
• If the operating button has an LED, connect the LED with the white
connector (B).
• In the case of a building management system, the other end of the cable
(C) must be connected with a normally open relay contact.
Â
Step 6: Switch on the 24 VDC power supply.
The red LED 602 flashes. This indicates that the controller is working but has
not yet been configured.
3.1.2. CONFIGURATION
Â
Step 1: Set the type of window using the DIP switches.
• The red LED 602 (LED-E on image page 6) flashes
• The types of window can be found on the website or with the motor.
Â
Step 2: Close all vents before continuing with the set-up.
3.1.3. MANUAL SET-UP
• Manual set-up uses the DIP switches and the SET-UP button.
• You can exit the procedure at any time by pressing the SET-UP button
for at least 5 seconds until the yellow LED 601 (LED-D on image page
6) flashes.