REXON GC1950R, Инструкция по эксплуатации

Страница: 8 / 16

5
3. Press the lock button (2) again to
stop the grooving cutter.
USING THE GUIDE RULE (FIG. 7)
1. Loosen the lock bolts (1) at the front
and rear base (2).
2. Insert the guide rule (3) through the
holes on the base.
3. Adjust to the desired width and
tighten the lock bolts (1).
CUTTING GROOVES (FIG. 8)
1. Hold the grooving cutter firmly with
one hand held on the switch handle
and the other hand held on the
auxiliary handle.
2. Turn the mahcine on and wait to its
full speed and move the machine
forword in alignment with the cutting
line.
NOTE: Do not allow the blade touch
the workpiece before it comes to full
speed.
3. Force the grooving cutter downward
to make sure the base touches the
workpiece when move the grooving
cutter forward to cut the groove.
Operating the Tool
WARNING! Never connect the plug
to the power source outlet until
all installations and adjustments
are completed and you have read
and understood the safety and
operational instructions.
WARNING! Forcing and applying
excessive pressure might allow the
blade to bend. Pinch or twist in the
cut can cause overheating of the
motor and dangerous kickback of
the tool.
Connecting to the Power Supply
Check that the power supply and outlet
used is in accordance with your marble
cutter. Have a look at the rating plate
of the motor, if any changes should
always be carried out by a qualified
electrician.
USING AN EXTENSION LEAD
The use of any extension lead will
cause some loss of power. To keep
this to a minimum and to prevent
overheating and motor burn-out, ask
advice from a qualified electrician to
determine the minimum wire size of
the extension lead. If the power cable
is broken, repair service is available at
your nearest service center.
TRIGGER SWITCH (FIG. 6)
1. Press the trigger switch (1) to turn
on the grooving cutter; release the
trigger switch to stop the grooving
cutter.
2. To maintain in a continuous
operation, press the trigger
switch (1) and the lock button (2)
at the same time.
WARNING! Avoid contact with the
terminals on the plug when installing
(removing) the plug to (from) the
power supply outlet. Contact will
cause a severe electrical shock.