REXON DH410R, Инструкция по эксплуатации

Страница: 5 / 16

2
breakage of parts, mounting and any
other conditions that may affect its
operation. A guard or other part that is
damaged should be properly repaired
or replaced by an authorised service
centre unless otherwise indicated in this
instruction manual. Do not use the tool if
the switch does not turn it on and off.
21. WARNING.
The use of any accessory or
attachment other than one recommended
in this instruction manual may present a
risk of personal injury.
22. HAVE YOUR TOOL REPAIRED BY
A QUALIFIED PERSON. This electric
tool complies with the relevant safety
rules. Repairs should only be carried
out by a qualified person using original
spare parts, otherwise this may result in
considerable danger to the user.
23. THROUGH POOR CONDITIONS OF
THE ELECTRICAL MAINS,
shortly
voltage drops can appear when starting
the EQUIPMENT. This can influence
other equipment (e.g. blinking of a
lamp). If the MAINS-IMPEDANCE
Zmax < 0.34 OHM, such disturbances
are not expected.
24. DO NOT USE SAW BLADES
MANUFACTURED FROM HIGH
SPEED STEEL.
25. KEEP THE FLOOR AREA AROUND
THE MACHIN LEVEL, well maintained
and free of loose material e.g. chips
and cutoffs.
26. USE CORRECTLY SHARPENED SAW
BLADES. Observe the maximum speed
marked on the saw blade. Ensure that
the machine is always fixed to a bench,
whenever possible.
Additional Safety Rules
For Demolition Hammer
1. Hold tools by insulated gripping surfaces
when performing an operation where the
cutting tool may contact hidden wiring
or its own cord. Contact with “live” wire
will make exposed metal parts of the tool
“live” and shock the operator.
2. Wear ear protectors when using the
tool for extended periods. Prolonged
exposure to high intensity noise can
cause hearing loss.
3. Wear a hard hat (safety helmet), safety
glasses and/or face shield. Ordinary
eye or sun glasses are NOT safety
glasses. It is also highly recommanded
that you wear a dust mask and thickly
padded gloves.
4. Be sure the bit is secured in place
before operation.
5. Under normal operation, the tool is
designed to produce vibration. The
screws can come loose easily, causing a
breakdown or accident. Check tightness
of screws carefully before operation.
6. In cold weather or when the tool has not
been used for a long time, let the tool
warm up for a while by operating it
under no load. This will loosen up the
lubrication. Without proper warm-up,
hammering operation is difficult.
7. Always be sure you have a firm footing.
Be sure no one is below when using the
tool in high locations.
8. Hold the tool firmly with both hands.
9. Keep hands away from moving parts.
10. Do not leave the tool running. Operate
the tool only when hand-held.
11. Do not point the tool at any one in the
area when operating. The bit could fly
out and injure someone seriously.
12. Do not touch the bit or parts close to
the bit immediately after operation; they
may be extremely hot and could burn
your skin.
13. Some material contains chemicals which
may be toxic. Take caution to prevent
dust inhalation and skin contact. Follow
material supplier safety data.
WARNING! DO NOT let comfort or
familiarity with product (gained from
repeated use). Replace strict adherence
to hammer safety rules. If you use this
tool unsafely or incorrently, you can
suffer serious personal injury.