1.
Turn off the car’s engine.
2.
Secure the dashcam to a place close to the original rearview mirror.
3.
Plug the GPS module into the GPS port and secure the module to a position close
to A-pillar of the car. The antenna receiver side (the side without 3M adhesive)
faces the outside and the side with 3M adhesive faces down. It should be properly
secured.
4.
Plug the charger into the car’s cigarette lighter. Connect the device to the cigarette
lighter through the car charger.
9
Installation
The charger extension cable can be wired along the edge of the windshield during
installation. The optional rearview camera should be mounted on the rear
windshield of the car. Pay attention to its orientation during installation. It can be
wired against or above the interior’s headliner. Plug the rearview camera
connector into its rear camera port of the device once the camera is securely
mounted. Adjust the position of the lens to make sure that it remains horizontal
with the ground. Start the engine to check the video operation of your device.
Note:
