7
G
Guarantee
ACCO Brands Europe warrants its products and their parts against
defects in materials and workmanship under normal use for a period
of 24 months from the original date of purchase. During this period we
will repair or replace a defective product or part subject to the following
warranty conditions:
The warranty applies only to defects in materials and workmanship
under normal use and does not extend to damage to the Product or
parts which result from:-
- alteration, repair, modification or service carried out by anyone
other than an authorised ACCO service centre.
- accident, neglect, abuse or misuse owing to failure to comply with
the normal operating procedures for a product of this type.
Nothing in this Warranty shall have the effect of excluding the liability of
ACCO in respect of death and personal injury caused by the negligence
of ACCO. This Warranty is offered (subject to these terms and conditions)
in addition to, and does not affect your statutory rights.
For any questions relating to your warranty, please contact your local
service agent (see back cover).
Additional Guarantee
ACCO Brands Europe guarantees the cutting blades of the shredder to
be free from defects in material and workmanship for 10 years from the
date of purchase by the original consumer.
*Please note that the cutter blades will be progressively worn down
by shredding fastened sheets (staples and paperclips) - this is not
covered in the warranty. The Auto+ 175X has been design to shred up
to 50 credit cards and 50 CDs/DVDs in the standard 2 year warranty
period. Any excessive credit card or CD/DVD shredding will invalidate the
extended cutter warranty.
These conditions shall in all respects be governed and construed in
accordance with English Law and subject to the exclusive jurisdiction of
the English Courts.
Australian Customers
This guarantee does not apply to Australian customers.
See warranty on page 73.
Maintenance
The rollers on the auto-feed mechanism may become dirty over time,
please wipe clean with a dry cloth to maintain maximum product
performance (see fig 7).
The auto-start infra-red sensor, located in the paper feed entry-slot, can
occasionally become covered in paper-dust causing the shredder to
run despite no paper being fed into the machine. Switch the shredder
off at the rear of the machine and carefully clean the sensor using a
cotton-swab (see fig 8).
Lubrication of the Shredder
Only use Rexel Oil Sheets (2101948 & 2101949) to lubricate. ACCO
Brands Europe accepts no liability for product performance or safety
when other types or brands of lubricants are used on any part(s) of
this machine. Rexel recommend using an oil sheet after the bin has
been emptied three times (and for on-going three bin cycle thereafter).
Insert the oil sheet into the manual feed slot and NOT in the auto-feed
chamber. Using an oil sheet in the auto-feed chamber will contaminate
the feed rollers preventing the auto-feed mechanism shredding. Follow
the maintenance instructions if the rollers become contaminated.
Credit Card Shredding
1
Lift up the paper loading door (see fig 4).
2
Insert the credit card into the roller as shown (see fig 6). Only shred
one credit card at a time.
3
Close the paper loading door.
Rexel encourages customers to recycle shredded paper. Please
note that shredded paper cannot be recycled if mixed with credit
card shards. If recycling, please separate shredded paper and
credit cards.
Shredder Accessories
We recommend that a paper waste sack for recycling shredded paper is
used on all models.
Accessory
Part Number Box Qty
Recycling Waste Sack
1765031EU
20 sacks
Plastic Waste Sack
40060
100 sacks
Oil Sheets
2101949
20
2101948
12
Self-cleaning Cutters
After emptying and replacing a full bin, the shredder will run in forward
for 4 seconds, stop for 2 seconds and then reverse for 4 seconds
to clear away any remaining paper from the cutter mechanism.
This unique ‘self-cleaning’ mechanism is additional jam prevention
technology from Rexel.
