REVV Generator 120 MK3, Руководство пользователя

Страница: 11 / 23

R E V V | G E N E R AT O R 1 2 0 M K 3
11
BACK PANEL
MAIN POWER CONNECTION
17
When plugging the amplifier into the mains A/C wall
receptacle, always make sure the amplifier power &
standby switches are in the off position. The Required
voltage & fuse ratings are marked on the amplifier,
verify that they are correct before plugging in.
MAIN & HT FUSES
18
The mains fuse & HT fuse are in place to protect you
& your amplifier from overload conditions. It is vitally
important that fuses with the same type and rating are
used when replacing. Fuse requirements are marked
on the rear panel of the amplifier. Always be sure to
unplug the amplifier from the mains before replacing
the fuses.
BIAS TEST POINTS
19
This amplifier is designed to allow the user to set the
bias of the power tubes without removing the chassis
from the headshell. Each pair of power tubes needs to
be set according to the tubes being used.
POWER TUBE FAULT FUSES
20
The power tubes are fused in pairs. Should a power
tube fail, the fuse will blow & take the pair of power
tubes out of service. This has the benefit of protecting
the amplifier, & also allows for continued playability, to
allow the user to finish the gig on the remaining pair.
The volume & tone will change but the show will go on.
Note: Should the amp be run with 2 power tubes
removed from service (bad or blown fuse), in order to
achieve a tone more consistent with normal 4 tube
operation the amp should be run with an impedance
setting of half the speaker cabinet rating. For example,
if the speaker cabinet is 8 ohms, use a 4 ohm speaker
jack on the amplifier, & if the speaker cabinet is 16 ohms,
use an 8 ohm speaker jack.
XLR OUTPUT & GROUND LIFT
21
The balanced output XLR jacks are a direct output from
Two notes Torpedo Embedded. By connecting these
outputs to front of house or an audio interface you can
capture your amplifier’s tone with no need for a cabinet
or microphone!