- 20 -
1
2
3
Note:
Microphones in new systems must be paired to the Base Station with each microphone
assigned to a unique channel on the Base Station.
Remember, microphones are always muted (flashing RED LED) when they are removed from the
Charger Base and the Mute button needs to be pressed to make it ―live‖ (flashing GREEN LED).
A microphone that is not paired will be indicated by a cycling RED-GREEN LED pattern. A Base
Station channel that is not paired to a microphone will not show any activity on the channel LED
(make sure unit is first powered on by observing GREEN backlit front panel display).
When channels are paired, both microphone and channel LEDs will flash RED as microphones are
removed from the Charger Base and flash GREEN when un-muted. Remember that only one
microphone can be paired to any single Base Station channel.
To pair an individual microphone to the Base Station:
1. Turn the microphone OFF (no LED activity). If the microphone is ON, press and hold the Mute
button for 10 seconds until the LED turns solid RED then release the button to turn the unit off. (do
not release the button when you hear two beeps).
2. Place the microphone unit into pairing mode by holding the Mute button down for seven seconds.
The LED will turn solid RED. Release the Mute button. The microphone is now in pairing mode.
3. Within one minute, push and hold the button for the desired channel on the Base Station for seven
seconds until the LED turns solid red then release. The LED for that channel will be solid red until
pairing starts, as indicated by a quick GREEN flash, then switching to flashing RED on both the
microphone and the Base Station (muted audio). Pairing is now complete.
Revolabs HD Venue
TM
Charger Base
When microphones are not in use, they should be properly inserted into the Revolabs HD Charger
Base. It is important to ensure that all system microphones are inserted fully in the base so that
charging will occur. Features of the base are shown in the following figure.
1. LED indicator
— power status indicator
2. Charger Bays
— charges up to 2 Microphones
3. Power Cord Receptacle
— power supply input, 9-24VDC (on rear)
