Network Camera
3
< Body >
①
IR LED
②
Lens
③
Rotation Base
④
Pan Base
⑤
Factory Reset Switch
⑥
Bottom Cover
⑦
Input/Output Device Ports
⑧
Cable Access Hole
⑨
Tilt Adjustment Screw
Side Cable Access Hole, Cable Access Hole
: Allows you to feed wires and cables for
connection to power, devices, and Ethernet.
IR LED
: The sensor in the middle of IR LEDs detects low illumination and the IR LEDs are lit at
night or under low lighting conditions.
Lens
: Fixed focus lens is installed. You can adjust the focus of the lens by turning the lens
clockwise or counter clockwise, and a focus fixation spring fixes the lens position.
Rotation Base
: Allows you to adjust the rotation angle by turning the rotation base clockwise
or counterclockwise.
Pan Base
: Allows you to adjust the pan angle.
Factory Reset Switch:
Use to return all settings to the original factory settings. See below for
details.
Bottom Cover
: Allows you to mount the camera to the wall or ceiling.
Input/Output Device Ports
: Allows you to connect the input/output device. See the section below.
Tilt Adjustment Screw
: Allows you to adjust the tilt angle.
Factory Reset
This will only be used on the rare occasions that you want to return all the settings to the original
factory settings.
CAUTION: When performing a Factory Reset, you will lose any settings you have
saved.
Cut off the power from the camera.
→
Poke a straightened paperclip into the factory reset switch
hole.
→
Turn on the power while holding the reset switch
→
Release the switch in about 5 seconds
after the Power LED blinks.
→
The camera resets to factory defaults and restarts after completing
the factory reset.
You can perform a factory reset while the camera is turned on by pressing the factory reset switch
and releasing the reset switch. A factory reset also can be performed remotely by running the INIT
program. The camera restarts after completing the factory reset. Refer to the INIT User’s Manual
for details on remote factory resetting.
