This guide contains important information. Please
keep it for future reference.
Designed by Reviver in California. Assembled in Taiwan.
RPlate is a registered trademark of Reviver © 2019 All
rights reserved.
CA WARNINGS
CAUTION:
For vehicles with paint protective film,
ceramic coating or matte finish use soap, water and dry
cloth to clean surface before installing license plate.
CAUTION:
Routinely check this product for proper and
safe condition. If there is any damage or broken parts,
remove product from use.
CAUTION:
If for any reason the screen (display) is frac-
tured or cracked, immediately remove this product from
use and contact Reviver Consumer Services for replace-
ment if under warranty.
CAUTION:
The display module should not be exposed to
harmful gases, such as acid and alkali gases, which
corrode electronic components.
CAUTION:
Disassembling the display module can cause
permanent damage and invalidate the warranty
agreement.
CAUTION:
Observe general precautions that are
common to handling delicate electronic components.
The glass can break, and front surfaces can easily be
damaged. Moreover, the display is sensitive to static
electricity and other rough environmental conditions.
WARNING:
The display glass may break when it is
dropped or bumped on a hard surface. Handle with care.
Should the display break, do not touch the electrophoret-
ic material. In case of contact with electrophoretic
material, wash with water and soap.
WARNING:
This product contains chemicals known to
the
State of California to cause cancer and birth defects or
other reproductive harm.
NOTICE:
Use mounting hardware sent with RPlate to
attach mounting bracket. Wipe car surface prior to install.
Ensure product installed correctly.
NOTICE:
Do not use product if it was damaged in an
accident.
NOTICE:
RPlate is sold as rear license plate. Consult with
applicable laws and regulations imposed by state agen-
cies with respect of display of the front license plate.
NOTICE:
Tools may be required to remove the
license plate, adapter, and foam.
Battery replacement Instructions:
RPlate includes a non-rechargeable lithium battery pack
designed by Reviver. For replacement, only use Reviver
products. For further instruction, please go to
www.reviver.com/legal
.
Battery safety:
Dispose of used battery pack properly. Only battery pack
provided by Reviver is acceptable for replacement.
DO NOT
incinerate used batteries.
DO NOT
dispose of batteries in fire, as batteries may
explode or leak.
DO NOT
recharge non-rechargeable batteries.
DO NOT
short-circuit the supply terminals.
DO NOT
expose to temperatures beyond the specified
temperature range.
DO NOT
crush or puncture.
DO NOT
open cells, do not disassemble battery packs.
DO NOT
expose contents to water.
DO NOT
connect with false polarity.
DO NOT
weld or solder to the battery’s body.
FCC NOTICE:
This device complies with Part 15 of the FCC rules. Op-
eration is subject to the following two conditions: 1) This
device may not cause harmful interference, and 2) This
device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device, pursu-
ant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE:
Changes or modifications to this unit not expressly
approved by Reviver could void the user’s authority to
operate the equipment.
FCC Declaration of Conformity
Trade Name: RPLATE
Model Number: ATT
Contains: FCC ID: XPY2AGQN4NNN
Contains: FCC ID: XPYNINAB1
Electronic waste:
To recycle product, visit your local
e-waste collection facility or local recycler. Reviver offers
a mail-back program for its products. Reviver will ensure
recycling and disposal are performed in an environmen-
tally sound manner that complies with all governmental
laws and regulations. To access the mail-back program,
reach out to the Reviver customer service.
Customer service contact:
Contact our consumer
support at
.
Warranty:
Subject to a limited two (2) year warranty.
Visit Terms of Sale and Use for full details. Reviver shall not
be liable for any incidental or consequential damages
for the breach or any warranty on this product. Some
jurisdictions do not allow the exclusion or limitation
of incidental or consequential damages, or limitation on
how long an implied warranty lasts, so the above limita-
9
!
