REVIER MANAGER RM4eco, Руководство пользователя

Страница: 29 / 59

29
5. INITIAL START-UP OF THE CAMERA
When the battery is put into the camera properly, please make sure that the
SD card has been inserted properly and locked into place.
Slide the switch inside the wildlife camera to SETUP. After a few seconds
the signal strength symbol will appear on the screen (see point 3 „Display“).
After 20-30 seconds, the network operator should appear on the screen
(e.g. „Vodafone“ etc.).
Please note: At least 2 bars should be displayed for the signal strength.
Otherwise, please change location (additional accessories available
for better signal strength). The camera refreshes the signal strength
approximately every 10 minutes.
Attention: If the signal strength is too weak or the battery performance is
too bad, it could happen that no pictures will be sent to the Reviermanager
app gallery.
Tip:
On SETUP you can check to see how the motion sensor works.
The red LED on the front of the camera only flashes when movement is
registered. This can also be used for optimal alignment and positioning of
the camera.
When there is sufficient battery power and signal strength, slide the switch
to ON.
When using the camera for the first time, check whether the camera triggers
a picture when there is movement. As soon as the camera is switched to
ON, the red LED flashes slowly for 10-15 seconds. After that the camera
is active. It triggers a picture if there is movement and reacts to commands
from the app.
Attention:
To protect the Reviermanager camera from weather influences,
please take care that water ( for example rain or molten snow) can flow
away freely and doesn´t form a puddle under the camera.
All further information & videos for the explanation can be found at:
www.reviermanager.at/faqs.html
English