CUSTOMER SERVICE: 800-973-8374
11
Frame Assembly Instructions
STEP 7
STEP 8
STEP 10
STEP 9
Install the batteries in your wireless remote
wireless remote control to verify that all of
the features are operational. If your
Flex 3
™
Adjustable Base does NOT operate, please
refer to the Troubleshooting section near the
end of this manual.
to assemble the Mattress Retainer Bracket.
Place your mattress on top of your power
base. Typical
Flex 3
™
Adjustable Bed Base
installation is now complete. If the base is
equipped with a programmable setting or
options, refer to the Remote Control Guide for
more information.
NOTE: If the power base is to be set
up without a headboard, simply install a
mattress on the frame. If a headboard is
to be installed, please follow headboard
installation instruction.
ATTENTION: Failure to follow the proper
installation instructions may result in
damage to your power base.
ONLY INSTALL AT CUSTOMER REQUEST.
issues with the mattress not staying on the base
when elevated, then the customer can install the
two corner bars at the foot-end of the bed.
NOTE:
ProGrip™ Base uses a
material near the foot
end to help prevent the
mattress from sliding off
the base when operating
head and foot lifts.
Use the Retainer Bolts (D) and Retainer Bar
Plate (E) to fasten the Mattress Retainer
Brackets (B) to the power base.
NOTE: Use only a manual screwdriver to
install the retainer bolts. DO NOT use a
power screwdriver to tighten the bolts. DO
NOT over tighten the mattress retainer
hardware.