CUSTOMER SERVICE: 800-973-8374
13
Power Base Assembly Instructions
STEP 11
1. Use the remote control to raise the head of
the base in order to gain access to the power
base frame.
2. Remove plastic cap and place the Inner
Headboard Bracket (D) into the round tube
frame making sure the bracket inserted into
the round tube. This will create a box shape.
Place the Headboard Bracket Bolt (G) with a
5/16 Inch Washer (J) through the pre-drilled
hole in the round tube frame and pass it
through the Inner Headboard Bracket. Use
the 5/16 Inch Washer (J) and the 5/16 Inch
Bracket. Use the 5/16 Inch Washer (J) and
5/16 Inch (K) and tighten the bolt in place.
Repeat for the opposing side of the power
base frame.
3. Place the open side of the outer headboard
bracket (E) onto the exposed square tube
of the inner headboard bracket (D). This will
a Headboard Bracket Bold (G) with a 5/16
Inch Washer (J) through the Outer Headboard
Bracket (E) and into Inner Headboard Bracket
(D). Use a 5/16 Inch Washer (J) and 5/16 Inch
Locking Nut (K) and hand tighten to allow
for adjustment. Repeat same procedure for
opposing side of the power base frame.
4. Firmly tighten the headboard bolts (not
included) to the end of the headboard bracket
assembly.
5. Measure the distance of the center to center
mounting holes in the headboard.
6. Measure the distance of the center to center
mounting holes in the headboard bracket
assemblies.
7. If the headboard brackets require adjustments,
loosen the bolts that are holding the outer
headboard brackets and move them to the
necessary distance. Reinstall the bolts and
Place your mattress on top of your power base.
Typical
Flex 9 Adjustable Base
is now
complete. If the power base is equipped with
a programmable setting or options, refer to the
Remote Control Guide for more information.
NOTE: Must Remove Head-Side Rail
Before Installing
Headboard Bracket Installation
(OPTIONAL)
