4
Troubleshooting
Service
Steering Trim:
Driving Tips:
Binding Procedure
Driving the Vehicle (continued)
If your Beastie Bug
™
requires repairs or replacement,
DO NOT RETURN TO RETAILER.
Contact:
Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
(217) 398-0007
[email protected]
REVELL, INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
A SUBSIDIARY OF HOBBICO
MADE IN SHANGHAI, CHINA
revell.com
© 2013 REVELL INC. PLEASE RETAIN PACKAGING FOR FUTURE REFERENCE.
CONTENTS AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
• If the controller sits idle (without input) for 2 minutes, it will go into Power Save Mode. The LED will begin fl ashing slowly. After 9
minutes without input, the controller will shut off.
•
Run the car on a fl at surface.
•
Watch the car instead of looking at the controller.
• Always release the throttle trigger right away following a crash to prevent damaging the electronics.
•
The vehicle should be operated in an area that has as much open space as possible with no people or animals nearby.
•
Do not operate this vehicle on the street.
To bind the controller to the receiver:
1. Hold the right trim button on the controller and turn on the controller. The LED on the controller will blink.
2. Turn on the receiver. The LED on the controller will turn solid.
3. Process is complete.
Problem:
The wheels won’t turn.
Solution:
Recharge the battery.
Problem:
The controller doesn’t function.
Solution:
Make sure the batteries are inserted correctly.
Insert new batteries.
Problem:
The car loses speed or comes to a stop.
Solution:
Recharge the battery.
Problem:
Controller LED fl ashing slowly (low voltage).
Solution:
Replace the controller batteries.
•
If the vehicle pulls right (when viewed from
behind), push the left
Õ
trim button.
•
If the vehicle pulls left (when viewed from
behind), push the right
Ö
trim button.
Steering Trim Buttons
RMXC3968 Instr.indd 4
RMXC3968 Instr.indd 4
6/21/2013 8:16:47 AM
6/21/2013 8:16:47 AM
Industry Canada Notice:
This device complies with Industry Canada licence-exempt RSS
standard(s).
1.Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device.
2.Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.