Note:
Before recharging and after every flight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.
charging the Helicopter
Pic. 1
Pic. 2
1.
Turn off the helicopter and the controller.
2.
Pull out the charging cable from the bottom of
the controller (pic. 1).
3.
Carefully plug the charging cable into the helicopter’s
charging port (pic. 2). The charging cable should fit
easily into the charging port – DO NOT FORCE.
Inserting the charging cable incorrectly may damage
the helicopter and cause injury.
4.
Turn the power switch on the controller to “ON”
(Charge) (pic. 3).
5.
The charge status LED turns green and shows that
charging is in progress (Pic. 4).
6.
Charging is complete when the LED turns red.
7.
After charging, turn the power switch to “OFF” and
remove the charging cable from the helicopter.
the helicopter can be flown for about 8 minutes after
approximately 30 minutes of charging.
Helicopter and controller
HeLIcoPter
coNtroLLer
Insert Batteries
1.
Remove the screw to
release the battery
cover and slide
downwards.
3.
Slide the battery
cover upwards and
screw in place.
Pic. 4
Pic. 3
2.
Insert six 1.5 V AA
batteries following the
polarity shown inside
the battery cover.
Counter-rotating
rotor blades
Stabilizer
Infrared signal emitter
Throttle stick
(up & down)
Forwards/backwards flight
Left/right flight
Charge status LED and
“POWER ON” LED
Power ON/OFF and
charge switch
Starting position
Note:
Before turning
on the controller, the
throttle stick must be
in the down position.
Battery cover
ON/OFF switch
Charging port
Band selector (A, B, C)
Right and left trim dial
Tail rotor
Undercarriage
Position light
english
