CLEANING / MAINTENANCE
CLEANING OF BATHTUB AND CONTROL PANEL
In order to clean the tub & control panel, take the magnetic key
and pass it in front of the infra-red of the control panel to deactivate it.
This will disable the sensors for 30 minutes or until the magnetic key is reapplied.
To reactivate the control panel, do the inverse operation.
- Only use liquid products (liquid soap).
- Don’t use abrasive products like « scouring cream » to avoid scratches on the tub surface « Gelcoat ».
- Furthermore, to eliminate calcareous marks settled by water, Reval recommends to use the scaler (Gel Servex).
Do not swill down the outside of the tub.
CLEANING OF THE HOT AND COLD WATER FILTERS
These filters are located at the hot and cold water inlet.
1)
Stop the water feeding of the bath.
2)
Dismount the filter tank with a claw key.
3)
Take the filter out.
4)
Clean the filter (in case of calcareous deposit, use the appropriate scaler and rinse
with clean water).
5)
Reassemble the parts.
CLEANING OF THE AIR WHIRLPOOL SYSTEM
-For the efficient functioning of the whirlpool system, the nozzles have to be cleaned on a regular basis ( at least once a
year).
-Functioning of a whirlpool’s nozzle. Air is
blown through the nozzle and is discharged
under the chromed air jet cap.
-There is a risk of heating the air jet cap if the
nozzles are not regularly cleaned. Layers of soap
or deposit can hinder the circulation of the air.
To clean the nozzles, please follow the next stages :
1
ère
Stage :
Switch off the whirlpool option and empty the bath.
2
ème
Stage :
Unscrew the air jet cap.
3
ème
Stage :
Clean the chromed air jet cap, the nozzle and the ball. Then reposition the air jet cap on the nozzle.
4
ème
Stage :
Check that it is correctly positioned on the nozzle. Switch on the bath and the whirlpool system to check they are working
properly.
15/16
AIR
NOZZLE
AIR JET CAP
CHROMED
