Advanced Configuration
The RT5X uses an OSD to configure the various possible settings on the device. Pressing the
‘Menu Button’ calls up the OSD, which is displayed on the top left hand corner of the screen.
The first line of the OSD shows the displayed menu option (e.g., in the above screenshot, the
Deinterlacer Mode). The second line of the OSD shows the selected setting for the option (in
this case, Motion Adaptive). A full description of the menu options and possible settings is
shown below:
Menu Option
Possible Settings
Description
Input
YPbPr
Cycles through each of the input ports. The detected source
resolution is shown on the second line for informational
purposes.
The input source can also be directly cycled, without calling
the OSD by pressing the ‘Input Button’ instead.
SCART RGB
Composite
S-Video
SCART CV
Output Res.
1080p (FILL)
Sets the scaled output. Depending on the input resolution, not
all of the modes will be available. PAL and related 50 Hz
formats (576p) can only be scaled to 1080p (OVER) and
1200p. The output resolution for 720p and 1080i is locked to
720p and 1080p, respectively.
NTSC and related formats (480p) can be scaled to all the
output resolutions listed. All 1080p modes use CEA standard
1080p (OVER)
1080p (UNDER)
1200p
Copyright RetroTINK LLC 2021
All Rights Reserved
Page of
6
13
