11
NOTE: This unit re12 volts to both the red and
yellow wires, otherwise it will not operate.
Locate the three wiring harnesses: Main Wiring Harness, Power
Wiring Harness and Speaker Wiring Harness (see “What’s in the
Box” on page 4). First connect the Main Wiring Harness to the back
of the radio. Then connect both the Power and Speaker Wiring
harnesses to the black female plug of the Main Wiring Harness.
After doing this, connect the bare wire ends of your power and
speaker wires to the appropriate power and speaker locations in
your vehicle (see Figure 4, “Wiring Diagram” on page 10). Have
your radio installed by a professional if this part of the install is too
difficult, or contact us if you have questions.
Installation Notes
• To prevent damage to the unit, do not connect the power
connector until you have completed the wiring process.
• This is a 12 volt negative-ground ONLY radio. If you
have a positive ground, or a 6-volt system, you need
to either convert to 12 volts or purchase a separate
inverter that would step up the voltage to 12 volts.
• Please note that the inverter must be rated at 10 amps
or higher in order for the radio to operate properly.
Rear AUX Input
The rear auxiliary input allows you to listen to any portable device
with standard headphone outputs. An example of an external
source would be a MP3 player, iPod
®
or iPhone
®
, portable CD player
or portable satellite radio receiver. To use this input, the auxiliary
cable must be routed to an accessible area during installation.
INSTALLATION INSTRUCTIONS
