RETOX 83 22 10, Инструкция по эксплуатации

Страница: 15 / 22

11
Using
B A
Temperature Display
 Directly after setup the ambient temperature (-9 °C to +50 °C) will
be shown on the temperature display (8).
Setup Options
 Use the hanging hole (4) to hang the clock on a nail or screw.
 Use the four suction cups (5) to stick the clock to almost any flat
surface. Ensure the surface is flat, clean and free from fat. Also
ensure that the suction cups are clean. Moisten the suction cups
a little bit before you stick the clock to the surface.
 Use the table stand (6) which is initially placed inside the rear
part of the housing (figure A ) to put the clock to a table top or
similar. To do so insert the table stand into the corresponding
recess at the bottom of the rear side of the clock (figure
B ).
You will find the table stand (6) inside the rear part of the housing.
Troubleshooting
If the hands of the clock do not move or run permanently, check the
following points for possible sources of interference.
 Check if the battery is inserted properly.
 Check if the battery’s capacity is sufficient.