Resvent iHope RS Series, Руководство пользователя

Страница: 249 / 261

F. Neonatal Ventilation
F-1
F. Neonatal Ventilation
WARNING
•
Check the neonatal flow sensor before use. DO
NOT use the neonatal flow sensor if the sensor’s
main body, tubing or connector is damaged or
occluded.
• DO NOT use the neonatal flow sensor if the
neonatal flow sensor tubing is twisted.
•
Before using the neonatal flow sensor for
ventilation, please run a system check after
configuration of all components required for
ventilation.
•
Configuration includes neonatal tubing, neonatal
flow sensor and accessories required for the
patient circuit. In the event that neonatal flow
sensor failure is detected in the system check,
please check the patient circuit and the neonatal
flow sensor for leak and/or occlusion. Replace the
neonatal flow sensor if necessary.
•
After conducting the system check, DO NOT add
or remove any accessories to or from the circuit,
so as not to alter the system resistance and
compliance.
•
If a neonatal flow sensor error occurs, stop using
the neonatal flow sensor until the error is fixed.
•
The neonatal flow sensor measures the gas flow
on the patient’s Y piece side.
•
However, the actual flow delivered to the patient
will be affected by system leakage between the
patient and the neonatal flow sensor.
•
Install the neonatal flow sensor in accordance
with the instructions provided in this manual.
Sensor installation errors will result in data
misinterpretation or incorrect ventilator setup.
• DO NOT place the neonatal flow sensor in a