- 15 -
R
esson
Technologies
Cone- cone measurement function
0
0
-0.05mm
d) After the cone measurement angle have been entered into the readout, the X axis zero will move as the
Z axis travel at -20 degree.
A) zero the dial indicator on one end of the work piece
0
Zero the dial
indicator
since in INCL mode, the X display
is set according to Z *tan(ANG),
therefore, zeroing the Z axis also
clear the X axis.
-0.05mm (the reading shown is
the error of the conical angle)
X axis zero position will follow the Z axis position
at the angle of ANG (-20 degree in this example)
operator just move the X axis to display =0.000
it is then at highly accurate -20 degree position
to the Z axis
B) After move the machine along the Z axis, the X zero position will automatically set
at-20 degree to the Z axis. By moving the X axis position to zero (X=0.000mm),
then the dial indicator will display the error of the conical work piece from a true
-20.0 degree.
User then make a fine adjust to the top slide angle to make a closer cut to achieve
a better cone angle accuracy.
Repeat the above procedures d) until satisfactory cone angle accuracy achieved.
RD-13L
R
esson
Technologies
ent
I
O
On
Off
ANG -20.0
0.000
0.000
RD-13L
R
esson
Technologies
ent
I
O
On
Off
ANG -20.0
123.550
0.000
Содержание RD-13L
