6
4.
To activate the Purify O3 Elite, place and hold finger on the On/Off
Touch Sensor for 2 seconds as shown in Figure 4. The Purify O3 Elite will
beep once and the Disinfection Progress Ring shown in Figure 5 will
illuminate to indicate the disinfection process has begun. The Battery
Life Indicator will also light to show the estimated battery life remaining.
NOTE:
The On/Off Touch Sensor is activated by covering the button - it will not
depress if pushed.
5.
Zip case fully closed (or secure lid, if utilizing container). The sanitizing/
deodorizing cycle for Purify O3 Elite is approximately 35 minutes in
length. During the cycle, the Progress Indicator Ring will darken to
indicate when the cycle is one fourth, halfway, and three-fourths
complete as shown in Figure 6. At the conclusion of disinfection, the
sanitizer will beep once and power off.
The sanitizer and accessories must remain in the closed case/container
for an additional 90 minutes to allow the residual ozone to dissipate.
Before use, run your PAP or nebulizer machine for 20-60 seconds with
mask and tubing attached to flush fresh air through accessories.
Your masks, tubing, Tees and accessories may be sanitized daily, as
desired.
Figure 6
Figure 4
Figure 5
On/Off Touch Sensor
Disinfection Progress Ring
1/4 cycle
1/2 cycle
3/4 cycle
