4
choose to run the cable along the wall outside the property, it is recommended to use
cable conduit to hide the cable and reduce the chances of it being tampered with.
3.
Drill 3 x 5mm mounting holes for the bracket’s wall plugs and 1 x 20mm hole for the
camera’s power and video connectors to pass through the wall or ceiling.
4.
Install the camera bracket using the supplied plugs and screws.
5.
Feed the video/power leads through the hole in the wall or ceiling, starting with the
largest connector, and then refit the camera on to the bracket and adjust the position
of the camera body as required by loosening the adjustment screw.
6.
The camera is supplied fitted with a 1m cable terminated with a RCA female plug and
a female power connector.
7.
Connect the male end of the power connector from the extension cable into the
camera along with the male RCA connector.
8.
Connect the RCA video end of the extension cable into video input of your TV/VCR/DVR.
9.
Tune your TV/VCR/DVR to auxiliary (AUX), A/V or video mode to view the camera.
(Note: R
efer to your TV/VCR/DVR’s owner’s manual for setting this up).
10.
Adjust the camera again if necessary to the desired viewing angle.
Connection Summar
y
Note:
If
the supplied extension cable is not long enough, the extension cable for this
camera can only be extended up to
30m in total length due to po
wer loss.
Extension Cable
12VDC Power
Supply Adaptor
TV / MONITOR
VCR / DVR
Video Signal
to Input
CAMERA