NanoMax
is the smallest full-featured security transmitter
in the industry. It is typically used to sense opening and
closings of doors and windows, but can secure just about
anything using its Strip & Stick
™
external contact holes. It will
alarm when the magnet is pulled away from the NanoMax or
when the external contact is opened.
Features
• Quick peel and press mounting
•
Small profile for a near
invisible
look
•
Most flexible magnet positioning in the industry
• Strip & Stick external contact holes
• 5 year warranty
Enroll
by placing the panel into wireless enrollment mode
and then sending an enrollment signal from NanoMax.
Alternatively, NanoMax can be enrolled by scanning its bar
code using the HeliLink app or by entering its 8-character
serial number on the interactive service provider’s web
portal.
Options for sending an Enrollment Signal
• Remove the battery tab, which can be done
without removing the cover, OR
• Touch the magnet to the sensor 5 times within
5 seconds, OR
• Remove the cover to trip tamper
Install
by removing the adhesive paper and adhering the
NanoMax and magnet on a door or window. Make sure to
align the alignment marks on the NanoMax and magnet
when mounting. Alternatively, NanoMax can be used with an
external contact instead of the reed switch.
External Contact
(not evaluated by ETL)
• If you are using the external contact then you
cannot use the reed switch.
• Use a
normally-closed
contact because
NanoMax will transmit an alarm when it sees
the external contact
open
.
• Do not use end-of-line resistors.
• Connect the contact to NanoMax by inserting
the contact’s wires into the two Strip & Stick
holes on the back of NanoMax.
• Additional wiring information can be found by
searching
www.ResolutionProducts.com
for
“external contact
wiring”.
RE622 Series CryptiX
™
NanoMax
™
Door Window Sensor
Use the Helix installation guide to verify proper system setup.
IN
STALL
G
U I D E
I
