ResMed Power Station II, Руководство пользователя

Страница: 4 / 161

2
For a full list of accessories see the Ventilation accessories guide
on www.resmed.com on the Products page under Service and
Support. If you do not have internet access, please contact your
ResMed representative.
Set up
Installing batteries before use
Refer to illustration B
1.
Open the battery cover at the rear of the Remote Alarm by
pushing in the latch and levering the cover away.
2. Insert two AA 1.5V batteries (not included).
3. Replace the battery cover, ensuring that it clicks into place.
A beep will sound once the batteries are inserted.
4. Press to check the functionality of the alarm. Refer to the
Testing the Remote Alarm instructions.
Note: Under normal usage conditions, new high quality type
LR6 (AA size) batteries should power the Remote Alarm for
approximately 12 weeks.
Connecting to the ventilator
Refer to illustration C
1.
Connect one end of the alarm cable to the (3 pin) input
connector on the Remote Alarm.
2. Connect the other end to the (5 pin) output connector located
at the rear of the ventilator. Once connected, the alarm will
beep and the Green Battery Good LED will blink once every
10 seconds.
3. Once set up is complete, press to check the functionality
of the Remote Alarm. Refer to the Testing the Remote Alarm
instructions.
CAUTION
The Remote Alarm cable is equipped with a push-pull
locking connector. To remove the cable from the ventilator,
gently pull on the connector. Do not twist its outer housing.
When an alarm is activated
1.
Check the patient’s status.
2. View the alarm message in the Alarm display on the Ventilation
device.
3. Follow the on-screen help (if available) or refer to the Alarm
Troubleshooting section in the User Guide that came with your
Ventilation device.
Connecting a second Remote Alarm
Refer to illustration D
If required, a second Remote Alarm can be attached to the first
Remote Alarm to enable a Remote Alarm to be placed in two
separate rooms or locations.
1. Connect the Remote Alarm as per the instructions in
Connecting to the ventilator .
2. Connect one end of the alarm cable to the output connector
(5 pin) of the first Remote Alarm.
3. Connect the other end into the input connector (3 pin) on the
second Remote Alarm.