Repeatershop SignalPro W18-23, Руководство пользователя

Страница: 23 / 28

Repeatershop.nl
Basecom b.v.
Ulgersmaweg 27a
9731BJ Groningen
I www.repeatershop.nl
E info@repeatershop.nl
T +31 (0)88 227 32 34
F +31 (0)88 227 32 33
Deutsche Bank 54.68.60.745
IBAN NL02 DEUT 0546 8607 45
KvK Groningen 02081942
BTW NL8208.00.533.B01
3G/4G-1800 Super High Gain
Fiberglass staafantenne
art. nr. A13513
Montage-instructies
Monteer de antenne met behulp van de bijgeleverde beugels aan de buis.
TECHNISCHE GEGEVENS
Frequentiebereik 1920-2170 MHz
Polarisatie Verticaal
VSWR ”
Versterking 9 dBi
PIM < -140 dBc (2 x 33 dBm carrier)
Ingangsweerstand Ÿ
Stralingshoek 360
0
Horizontaal, 11
0
Verticaal
Maximaal vermogen 100W
Blikseminslagbeveiliging DC Ground
Connector N-Female
Afmeting Ø 38 x 1000 mm
Gewicht 1 Kg
Reflector Copper
Behuizing Fiberglass grey
Windbestendigheid bestand tegen windsnelheden tot 210 km/h
Bedrijfstemperatuur -40
0
C – 55
0
C
Bevestiging Buis met een diameter van 38 – 52 mm
Beugel
Beugel
Montagebuis
Antenne
PREMIUM
LINE
23
More about “AlC” indication: Alc indicates the strength of input signal or receiving
power of the repeater. Flashing Alc means that the repeater has strong receiving
power.
LED Status Meaning SolutionMethods
ALC
status
Remain still
Output power is
not weak or just
suitable
Check coverage, leave it as it is if it’s
good; take the actions mentioned below
to increase signal if coverage is not good.
1. Adjust the antenna direction or location
to get stronger receiving signal.
2. Replace current antenna with higher
gain to get stronger receiving signal.
Flashing but current
gain is not more than
30dB and less than rated
gain
Full output power Working properly
Flashing but current gain
is more than 30 dB Too strong
receiving signal
Working properly, but the signal is too
strong. Actions recommended:
1. Adjust the antennas’ directions or
locations to low down input power.
2. Reduce the repeater’s gain by external
attenuator or replace with low gain
antenna if the methods listed above
don’t work.
Note: The flashing ISO and Alc status indicate that ISO and Alc functions are working
properly, and the problems of self-oscillation and strong signal are fixed. In most
cases, there is no need to take any measures from your part, except for deep self-
oscillation or too strong signals. However, your actions are not mandatory, since
self-adaptive repeater system automatically solves the problems.