7
0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Operation
05 BEFORE USE
06 DURING USE
Operation with the Vision 500 control panel
- Rinse out the whirlpool with cold water.
- Close the bathtub drain.
- Fill the whirlpool with hot water.
Important:
Since the piping system must be partially filled with water before the bathtub can be
filled, it takes some time for the water to visibly collect in the tub.
To enable the use of all functions, fill the whirlpool up to around the overflow with the user(s)
inside.
The keylock is activated when the
key flashes, irrespective of which key is pressed.
All functions are blocked (please refer to the following page).
You can select a function by pressing the corresponding key.
The key is illuminated for as long as the function is active.
The corresponding keys are also illuminated for functions which are
selected by the massage programme.
If a key flashes quickly after being pressed, it is not possible to carry out the function selected. This
is because one of the conditions necessary for the function has not been met, such as not enough
water in the whirlpool.
Turns the air massage on or off when output is set to medium (even when the tub is
empty). A few minutes after the bath, when the bath water has drained off, the key
flashes until the blow-out and fresh water rinsing (special accessories) automatic pro
-
grammes are completed.
Содержание Vision 1000
Страница 27: ......