REPA ECO, Инструкция по эксплуатации

Страница: 10 / 44

10
PROBLEMS CAUSES SOLUTIONS
The programmer does not regenerate
automatically or when the start up
button is pushed
Power supply disconnected Connect
Damaged engine Replace engine
Damaged card Replace card
The programmer does not regenerate
automatically but only by pushing the
start up button
Daily regeneration has not been set Set up regeneration
Lack of softened water between
two cycles
Incorrect regeneration
Repeat the regeneration cycle checking
that the correct amount of salt is provided
Polluted resins Wash or replace resins
Wrong set up of the quantity of salt Check and set up again
Mixing screw too fastened Unfasten and check hardness
External by-pass, if present, open Close by-pass
Failure in brine suction
Insufficient input pressure Set at least 1.4 bar
Output pipe blocked Remove obstruction
Obstructed injector Clean injector
Damaged injector Replace
Valves 2 and 6 blocked in
the open position
Remove the cause of the block
Valve line not sealed Replace the whole valve line
An excessive quantity of brine is fed
into the tub
Valve 1 remains open
Manually activate the valve to remove
the cause of the block
The input speed has not been checked Remove and clean the adjuster
Valve 2 does not remain closed during
suction Manually activate the valve to remove
the cause of the block
Air suction in the connection pipe to
the tub Check the tightness of brine connector
and pipes
Excessive quantity of salt set
Set up again following the indications of
the relevant table
Salt consumption not corresponding to
what is foreseen
Wrong adjustment Set up again
Damaging bodies in the brine flowmetre Remove and clean the flowmetre
Intermittent or irregular brine suction
Insufficient input pressure Set at least 1.4 bar
Damaged injector Replace injector
After regeneration water has not been
softened
The softener did not regenerate Repeat regeneration
Salt shortage in the tub Refill the salt in the tub
Lack of resins Replace resins
Excessive or insufficient capacity of the
counter-washing
Wrong type of adjuster Replace
The adjuster is obstructed Remove and clean
Water comes out from the tub after
regeneration
Membrane 1 remains open
Manually activate it to remove
impurities blocking it or replace the
membrane series
Hard operation water seeping
Wrong regeneration Repeat regeneration
O-ring 44F damaged Replace
External by-pass, if present, open or
mixing screw adjusted incorrectly Close the by-pass or adjust the mixing
screw