Operating Instructions
REOVIB 51310
1
Technical Safety Information for the User
This description contains the necessary information for the correct application of the product described
below. It is intended for use by technically qualified personal.
Qualified personnel are persons who, because of their training, experience and position as well as their
knowledge of appropriate standards, regulations, health and safety requirements and working conditions,
are authorised to be responsible for the safety of the equipment, at all times, whilst carrying out their
normal duties and are therefore aware of, and can report, possible hazards (Definition of qualified
employees according to IEC 364)
Safety Instructions
The following instructions are provided for the personal safety of operators and also for the protection of
the described product and connected equipment.
Warning!
Hazardous Voltage
Failure to observe can kill, cause serious injury or damage
•
Isolate from mains before installation or dismantling work, as well as for fuse changes or post
installation modifications.
•
Observe the prescribed accident prevention and safety rules for the specific application.
•
Before putting into operation check if the rated voltage for the unit conforms with the local supply
voltage.
•
Emergency stop devices must be provided for all applications. Operation of the emergency stop must
inhibit any further uncontrolled operation.
•
Electrical connections must be covered
•
The earth connection must be checked, for correct function, after installation.
•
After switching off the unit, some internal components will still be charged due to capacitance.
•
Before opening the unit wait at least five minutes to allow capacitors to discharge.
Specified Use
The units described herein are electrical controllers for installation in industrial plant.
They are designed for power adjustment on vibratory feed equipment.
The units conform to the directive 89/336/EWG
EMC - Directive
Contents
Technical Safety Information for the User ............................................................................................ 1
1.0 Description................................................................................................................................... 2
2.0 Function....................................................................................................................................... 2
3.0
Technical Data
............................................................................................................................... 2
4.0 Declaration of Conformity.............................................................................................................. 2
5.0 Connections ................................................................................................................................. 3
6.0 Dimensions .................................................................................................................................. 3
7.0 Ordering Codes............................................................................................................................ 3
!
