__________________________________________________________________________________
© Chr. Renz
MR
10/18
4.7
Release contact
At the factory, the POWER2CAR STEEL wallbox is equipped with a wire jumper between "+" and "IN"
of the terminal strip (table 3 no. 2) of the charge controller. On the customer side, this connection can
be used for an external charging release. In this case, an external potential-free contact controls the
charging release (e.g. separate key switch, ripple control receiver or similar).
4.8
Setting the current intensity on the dip switch block
Figure 7
Component
Description
DIP
Charging current setting to the vehicle
DIP 1 ON, rest OFF => 10 A
DIP 2 ON, rest OFF => 16 A
Activation RS485 interface
DIP 8 OFF => RS485 switched off
DIP 8 ON => RS485 switched on
Table 4
